Mustafa Salim Al-Rashidi
When I want to create the three surfaces for simulating dam break (surfaces for reservoir, dam & remain region downstream the dam) I choose from (Geometry >> Creation >> Straight line) to surround the surfaces by lines and after that I convert the lines to polygons. But the problem is when I want to create the line when I click by mouse the first point near the reservoir the point is fixed outside the image not in the actual location I choose.
I dont know if this method is correct or not to create the surfaces.
Thank you very much
MSc. student Mustafa Salim
|Create surfaces||Mustafa Salim Al-Rashidi||07/09/2019 09:48|
|Create surfaces||Enrique Escolano||24/10/2020 18:17|
|Create surfaces||Enrique Escolano||24/10/2020 18:19|