Forums
Error: wrong # args: should be "PWViewOutputWin filename name date basename"
Adina Moraru
25/01/2021 16:59:00 Error: wrong # args: should be "PWViewOutputWin filename name date basename" Hi, I am running a hydrodynamic steady flow model in Iber 2.6 and I get the following error few seconds after starting the calculation: wrong # args: should be "PWViewOutputWin filename name date basename" wrong # args: should be "PWViewOutputWin filename name date basename" while executing "PWViewOutputWin $filename $name """ (procedure "IberPreMenu::PWViewOutput" line 51) invoked from within "IberPreMenu::PWViewOutput" invoked from within ".gid.bitmapsIberPreBar.7 invoke " invoked from within ".gid.bitmapsIberPreBar.7 instate !disabled { .gid.bitmapsIberPreBar.7 invoke } " invoked from within ".gid.bitmapsIberPreBar.7 instate pressed { .gid.bitmapsIberPreBar.7 state !pressed; .gid.bitmapsIberPreBar.7 instate !disabled { .gid.bitmapsIberPreBa..." (command bound to event) What does it mean? I have tried to rename the project (I was initially using "." and "_", but opted later for only letters and numbers), and even to transform it to the "right" type of problem (although it was originally created in Iber 2.6), but it does not work. I get the same issue both when attempting to run on CPU than on GPU. I would appreciate some guidance. Thanks in advance, |
Error: wrong # args: should be "PWViewOutputWin filename name date basename"
|
Adina Moraru | 25/01/2021 16:59 | |
 Error: wrong # args: should be "PWViewOutputWin filename name date basename"
|
Marcos Sanz Ramos | 26/01/2021 09:00 | |